Thicknesses range from 5 16 to 3 4 inch and the proper.
Roof sheeting 16 on center.
The minimum plywood for roofing.
Installation details shall conform to sections 2304 7 1 and 2304 7 2 for floor and roof sheathing respectively.
H clips provide additional stiffness between bearing points for the unsupported edges of wood panel plywood or osb roof sheathing along with the necessary 1 8 gap for expansion as shown below illustrated on a bag of simpson h clips.
Panels are rated 32 16.
I only use 1 2 osb on roof sheathing but the apa rating of the osb does allow for 24 centers.
Sheathing should be a minimum of 19 32 inch thick.
Rafters run from the peak of the roof.
3 drill point no 12 14 x 38mm long into steel or type 17 drill point no 12 11 x65mm long into timber.
That means it can be used at 24 in.
The typical thickness range for sheathing is 3 8 to 3 4 inch.
Class 3 hex flange head epdm seal self drilling no.
For rafters or 16 in.
Huber s zip system sheathing which we are using on the fhb house has a span rating of 24 16 for 7 16 in.
Roofs are framed with rafters or trusses which are rafters joined by internal braces so they install as a single component.
8d ring shank nails should be used instead.
Now the fact that you are on 16 centers 7 16 would be fine although i probably would still use 1 2 out of habit.
What about the roof sheathing at 24 in.
For subfloors zip s 1 2 in.
Never attach roof sheathing with staples.
Osb comes in 4 by 8 foot sheets as does plywood but the manufacturing process allows the production of longer and wider ones.
The skeleton of a roof is formed with rafters or trusses generally spaced 16 inches or 24 inches apart from the center of one rafter to the center of the next.
To stabilize the rafters support the roofing material and hold the entire roof together roof sheathing is installed.
Just remember with all sheathing to space the joints 1 16 1 8.
Fasten roof sheathing panels properly fasten panels with a minimum of 8d common 0 131 inch by 2 1 2 inch nails spaced a maximum of 6 inches on center at supported panel ends and edges.