Roof Safety Mesh Installation

The longitudinal wires are spaced at 150mm centres with crosswires spaced at 300mm centres.

Roof safety mesh installation.

Complies with the requirements of australian standard as4389 1996 for safety mesh with galvanised coating grade w02z. If safety mesh is used ensure it. Our roof mesh comes in bare stainless steel and black pvc coated stainless steel wire. Same day despatch when your order is received by 9am for delivery.

Ausmesh 300 safety wire mesh ensures a safe roof work environment and it is so simple to install. Retains insulation materials and continues to provide protection after roof construction. If securely fixed safety mesh provides fall protection for roof installers and offers long term protection against falling for maintenance and repair workers. Safety mesh consists of 2mm galvanised wire with a tensile strength exceeding 450 mpa.

Installation of roof safety mesh as a primary means for fall protection when working at heights in domestic commercial and industrial building applications that use metal or timber purlins or a tested supporting member. Roof safety mesh product is available for purchase in 50 metre rolls. When used for roofing safety mesh becomes a permanent fixture for the life of the building and provides the required safe working environment throughout initial roof. Installing roof safety mesh before your workers even step foot on the roof will protect staff from falling hazards while on the job and those working underneath also.

Provides fall protection for roof installers and offers long term fall protection for maintenance and repair workers. The longitudinal wires are spaced at 150mm centres with cross. Means for demonstrating compliance with this standard are given in appendix b. Safety mesh does not prevent falls from the edge of a roof or through holes in a roof so it should always be used in.

The provision of a permanent safe working environment throughout the roof installation and for future maintenance work can be achieved by using the safety mesh system over the entire roof plane. Roof safety mesh is manufactured from resistance welded stainless steel wire measuring 2 00mm in diameter with longitudinal wires spaced at 150mm and transverse wires spaced at 300mm. Also used to support underlays where spans fall outside recommended distances. Safety mesh is designed to prevent internal falls through a roof.

Galvanised safety mesh complying with as nzs 4389 2015 for use in commercial roof applications where falling from high hazards exist. Staging on the roof surface to spread the loads safety mesh secured under fragile roofing or skylights. Stainless steel roof safety mesh provides fall protection for roof installers and long term protection against falling for maintenance and repair workers.